The District Bridge Engineer will sign the final design plans. Current Note 2(b) Wording: Provide at no expense to the Department four sets (three sets to District and one set to Central Office Bridge Division) of construction drawings (22 x36 ), calculations, erection methods, and detailed erection plans for approval. Shop Drawings must list Name of Fabricator and Plant address. Drawing s text size must meet or exceed minimum font size listed in Design Manual. Design/Contract Drawings to be submitted as 11 x17 or 22 x Shop Drawings to be submitted as full size (22 x 34 ). Approval Drawing Note 2(b) is revised as follows: 1. These smaller size drawing sheet Shop drawings may be used but must be submitted to the Department using a consolidation of up to four (4) 8 1/2 x 11 drawings on a full size drawing sheet (see Layout Sketch on page 2). The CONSPAN shop drawings previously have been submitted on 8-1/2 x 11 drawings as this sheet size has advantages for shop personnel performing the fabrication. In addition, our Materials and Testing Lab requires the CONSPAN drawings to list the location of the Fabrication Plant to be able to schedule the required inspections. 13 Bureau of Project Delivery Bridge Design and Technology Division Ap(Revised April 2016) Interim Revision to Bridge Standard Drawing(s) Drawing PE (Change #1), approved Approved Structure Product Item 30, CONSPAN - Drawing Size & Listing Fabrication Plant location The Department now requires shop drawings be submitted as full size drawings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |